Section 11 Quiz: Electrical
Get ready to take a short quiz! You can take the quiz as many times as necessary to achieve a passing score. This Quiz should be completed in 30 minutes. 70% of the correct answers are required to pass.
Quiz Summary
0 of 9 Questions completed
Questions:
Information
You will not be able to take the quiz or exam until you select the agreement box and fill in your name.
You have already completed the quiz before. Hence you can not start it again.
Quiz is loading…
You must sign in or sign up to start the quiz.
You must first complete the following:
Results
Results
0 of 9 Questions answered correctly
Your time:
Time has elapsed
You have reached 0 of 0 point(s), (0)
Earned Point(s): 0 of 0, (0)
0 Essay(s) Pending (Possible Point(s): 0)
Categories
- Not categorized 0%
-
PASS: No. Try Again
-
PASS: YES. Congratulations!
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- Current
- Review
- Answered
- Correct
- Incorrect
-
Question 1 of 9
1. Question
To conduct work on energized equipment, what information is not required to be present on an Energized Work Permit?
CorrectIncorrect -
Question 2 of 9
2. Question
When grounding portable generators, the grounding rods or pipe electrodes shall be unbroken ____ ft lengths and driven to full depth.
CorrectIncorrect -
Question 3 of 9
3. Question
When grounding portable generators and rock bottom has been encountered, the electrode shall be driven at an angle not to exceed _______ degrees from the vertical or shall be buried in a trench that is at least ______ft deep.
CorrectIncorrect -
Question 4 of 9
4. Question
What shall be ensured with respect to pneumatic tools that are used on or around energized lines or equipment?
CorrectIncorrect -
Question 5 of 9
5. Question
Tower erection shall be discontinued in high wind or other adverse weather conditions that could make the work hazardous except ________.
CorrectIncorrect -
Question 6 of 9
6. Question
Before stringing parallel to an existing energized transmission line, a determination, by ______, shall be made to ascertain whether dangerous induced voltage buildups will occur, particularly during switching and ground fault conditions.
CorrectIncorrect -
Question 7 of 9
7. Question
A ground shall be located at each side and within ________ ft of working areas where conductors, sub-conductors, or overhead ground conductors are being spliced at ground level.
CorrectIncorrect -
Question 8 of 9
8. Question
Before using the live-line bare-hand technique on energized high-voltage conductors or parts, a check shall be made of: (Select all that apply)
CorrectIncorrect -
Question 9 of 9
9. Question
What is true about guarding underground openings? (Select all that apply)
CorrectIncorrect